Connecting the Bluetooth module

Hexy Questions, Problems and Suggestions
#1

Any instructions on connecting the bluetooth unit to the servo board?

#2

Yup, right here:
github.com/ArcBotics/Hexy/wiki/Bluetooth

#3

thank you very much.

The picture in the instructions looks like a old board; different from the one I received.
Does the pin layout same as the on I have?

Thanks,
Peter

#4

Only difference is the color, the rest is all the same.

#5

Hi

I was able to insert the BT module in and the red light becomes steady after I paired and connected to it on my mac.
However, when I type “V” in a serial terminal, there was no response. The serial terminal is able to connect to the BT module without problem as it says connected, 9600 8-N-1

What went wrong?

#6

I tried to press the center button on the servo board and got a response from the serial terminal:

AT+BAUD4

but other than that, there are no other responses…

#7

Did you make sure to disconnect the usb first?

#8

Yes, USB was not connected at all.
Anything else I need to check?

#9

Which version of the firmware are you using?
Does it return on ‘V’ when using the usb?

#10

Hi

I use the latest version 2.0
There is no response when I typed “V” in a serial terminal

#11

ok, chose the wrong. the version returned was “SERVOTOR32_v2.0”

#12

Hi

Any idea why I can use USB and not Bluetooth?

Thanks!